Remove/Install Complete Outside Mirror - AR88.70-P-9000CLW
Model 205.3/4
Shown on left side of vehicle, model 205.3 with code 270 (GPS antenna), code 274 (Telephone antenna) and code 501 (360° camera)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Completely open side window | ||
| 2 | Remove door trim | AR72.10-P-1000LW | |
| 3 | Separate electrical connectors (2) | ||
| 4 | Unclip electrical connector (3) from bracket and disconnect | Model 205.3/4 with code 270 (Aerial for GPS) Model 205.3/4 with code 274 (Telephone antenna) Model 205.3/4 with code 501 (360° camera) |
|
| 5 | Press grommet (4) into door | ||
| 6 | Remove adhesive strips (5) | ||
| 7 | Remove bolts (6) | ||
| 8 | Unhook outside mirror (1) from door | Carefully hook outside mirror (1) into door. Otherwise it may be damaged. |
|
| 9 | Guide electrical wiring harness of outside mirror (1) through door | Guide electrical connectors through door one after the other. Otherwise they may be damaged. |
|
| 10 | Install in the reverse order | ||
| 11.1 | Calibrate 360° camera in outside mirror (1) with diagnostic system | Model 205.3/4 with code 501 (360° camera) If the left or right outside mirror (1) has been removed. |
|
| AD00.00-P-2000-04B | |||
| 11.2 | Calibrate all the cameras for the 360° camera system using the diagnostic system | Model 205.3/4 with code 501 (360° camera) If the left or right outside mirror (1) has been removed. |
|
| AD00.00-P-2000-04B | |||
| Check | |||
| 12 | Check outside mirror (1) for proper function |