Remove/Install Line From Cartridge To Inerting System In Engine Compartment - AR86.10-P-0219LWE
Model 205, 253 with engine 177, 264, 274, 276 with code 2U8 (Alternative refrigerant)
Model 213 with engine 177, 256, 264, 274, 276 with code 2U8 (Alternative refrigerant)
Model 238 with engine 256, 264, 274, 276 with code 2U8 (Alternative refrigerant)
Fig 1: Line From Cartridge To Inerting System Components Location - Engine 264 in Model 205 With Code 2U8
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove rear fender liner in right front fender. | Model 213 with engine 177, 256, 264, 274, 276 | AR88.10-P-1300LWE |
| With code 2U8 (Alternative refrigerant) Model 238 with engine 256, 264, 274, 276 with code 2U8 (Alternative refrigerant) |
|||
| Model 205, 253 with engine 177, 264, 274, 276 | AR88.10-P-1300LW | ||
| 2 | Open clamp of piping (1) and remove piping (1) from inerting system cartridge (4). | With code 2U8 (Alternative refrigerant) |
|
| 3 | Remove air duct segment with dust filter below the right engine compartment cover. | ||
| Model 213 with engine 177, 256, 264, 274, 276 With code 2U8 (Alternative refrigerant) | AP83.00-P-8381C | ||
| Model 238 with engine 256, 264, 274, 276 with code 2U8 (Alternative refrigerant) Model 253 with engine 177, 256, 264, 274, 276 with code 2U8 (Alternative refrigerant) |
|||
| Model 205 with engine 177, 264, 274, 276 with code 2U8 (Alternative refrigerant) | AP83.00-P-8381B | ||
| 4 | Open clamp (3) and remove piping (1) from distributor. | ||
| 5 | Expose piping (1) and remove. | ||
| Check | |||
| 6 | Check piping (1) for damage and plugging. | If there is a problem, ↓ Replace piping (1). |
|
| 7 | Install in the reverse order |