Remove/Install Line From Cartridge To Inerting System In Engine Compartment - AR86.10-P-0219LWE
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205, 253 with engine 177, 264, 274, 276 with code 2U8 (Alternative refrigerant)
Model 213 with engine 177, 256, 264, 274, 276 with code 2U8 (Alternative refrigerant)
Model 238 with engine 256, 264, 274, 276 with code 2U8 (Alternative refrigerant)
Fig 1: Line From Cartridge To Inerting System In Engine Compartment Components Location - Model 253 With Engines 264;274 With Code 2U8
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove rear fender liner in right front fender. | Model 213 with engine 177, 256, 264, 274, 276 | AR88.10-P-1300LWE |
| with code 2U8 (Alternative refrigerant) Model 238 with engine 256, 264, 274, 276 with code 2U8 (Alternative refrigerant) |
|||
| Model 205, 253 with engine 177, 264, 274, 276 | AR88.10-P-1300LW | ||
| 2 | Open clamp of piping (1) and remove pipin (1) from inerting system cartridge (4). | with code 2U8 (Alternative refrigerant) |
|
| 3 | Remove air duct segment with dust filter below the right engine compartment cover. | ||
| Model 213 with engine 177, 256, 264, 274, 276 | AP83.00-P-8381C | ||
| with code 2U8 (Alternative refrigerant) Model 238 with engine 256, 264, 274, 276 with code 2U8 (Alternative refrigerant) Model 253 with engine 177, 256, 264, 274, 276 with code 2U8 (Alternative refrigerant) |
|||
| Model 205 with engine 177, 264, 274, 276 with code 2U8 (Alternative refrigerant) | AP83.00-P-8381B | ||
| 4 | Open clamp (3) and remove piping (1) from distributor. | ||
| 5 | Expose piping (1) and remove. | ||
| Check | |||
| 6 | Check piping (1) for damage and plugging. | If there is a problem, ↓ replace piping (1). |
|
| 7 | Install in the reverse order |