000 588 05 21 00 Roller Brake Test Stand - WS42.00-P-0006B
WARNING: This page is about a different car, the 2020 Mercedes-Benz SLC43 AMG, 2019 Mercedes-Benz SLC43 AMG, 2018 Mercedes-Benz SLC43 AMG, and 2017 Mercedes-Benz SLC43 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model all (4xWD, BUS, CAR, Light transporter, smart)
Use in FG 42/43/Set B
Purpose:
Car roller brake test stand for checking brake forces at wheels.
Test equipment category CAT_B.
Procurement information:
This criteria catalog is intended as an aid for selecting one of the commercially available variants of a workshop equipment item. It merely describes the minimum requirements for fulfilling the Mercedes-Benz standard. No reference is therefore made to manufacturer-specific equipment or items.
Minimum requirements:
International technical standard equipment for car brake test stand:
- Roller set with rideover load of at least 4 t
- Roller set with usable test width of 800 to 2, 200 mm
- Test speed ≥4 km/h
- Engine power approx. 2x4 kW
- Galvanized roller set
- Plastic-coated roller surface with tire-to-road friction coefficient for tire/roller when dry 0.7/wet 0.5
- PC with printer for printing out test log
- Remote control for controlling brake test stand
- Startup blocking protection
- Automatic roller brake for testing automatic vehicles
- Pedal force meter
- Switchover mode from manual to automatic mode
- Automatic on/off circuit and automatic restart
- Standardized data interface for data transfer (e.g. USB, LAN etc.)
- Lockable main switch
Optional:
- Retractable aid
- Pit safety device for pit installation
Supplement for use with vans:
- Rollers with rideover load of at least 5 t
- Roller set with usable test width of 800 to 2, 200 mm
- Preinstallation for checking trip recorder and tachographs
- Simultaneous display
Please note the following, depending on the country:
- While using ASA Life Stream, the use of a second LAN interface is required