LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> C300 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 239 (Brakes - Hydraulic & Mechanical System - 172 Chassis - 1 Of 2) >> General Information >> Notes On Installing Brake Wear Indicator Contact Sensors - AH42.10-P-0003-01CW

Notes On Installing Brake Wear Indicator Contact Sensors - AH42.10-P-0003-01CW

WARNING: This page is about a different car, the 2020 Mercedes-Benz SLC43 AMG, 2019 Mercedes-Benz SLC43 AMG, 2018 Mercedes-Benz SLC43 AMG, and 2017 Mercedes-Benz SLC43 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 117, 118, 156, 166, 167, 172, 176, 177, 204, 207, 212, 217, 218, 222, 231, 242, 243, 246, 247, 292, 463 

There is one variant on the front axle:

The following variants exist at the rear axle:

When replacing the Brake pads, reinstall the Brake pad wear sensor at the same position.

IMPORTANT Route or install right front Brake pad wear sensor line (2) or electrical connector (1) as shown in the picture.

Shown on front axle on Model 204.041 

G13845858Courtesy of MERCEDES-BENZ USA

IMPORTANT Route or install right rear Brake pad wear sensor line (3) or electrical connector (4) as shown in the picture.

Shown on rear axle on Model 204.041 

G13845859Courtesy of MERCEDES-BENZ USA

For reasons of replacement part simplification, install the Brake pads so that the Brake pad wear sensors can be reinstalled at the corresponding assembly positions. The corresponding assembly position of the Brake pad wear sensors is specified in the list below.

G07069152Courtesy of MERCEDES-BENZ USA

Front axle version 5 

Front axle, version 6 

Rear-axle version 9