Detach/Mount Connector - AR42.45-P-0820-02LW
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2023 Mercedes-Benz E63 S AMG, 2023 Mercedes-Benz E53 AMG, 2023 Mercedes-Benz E350, 2022 Mercedes-Benz E53 AMG, and 2022 Mercedes-Benz E350. However, it is still accessible from the selected car via links, so may be relevant.
Model 205
Model 213
Model 238
Model 253
Model 463
as of model year 2019
 Courtesy of MERCEDES-BENZ USA
|
Always replace electrical connector (1) in the event of damage to the electrical connector (1), bracket (2) or lock (3). Otherwise the electrical connector (1) detaches from the ESP® control unit (N30/4).
Disconnect electrical connection (1)
- Push lock (3) upwards (arrow) until the release (4) is exposed.
- Press release (4), hold down, and swing bracket (2) upwards to the end stop.
The swinging action of the bracket (2) pushes the electrical connector (1) slightly out of the jack in the
control unit (N30/4). Do not use tools.
- Disconnect electrical connector (1) from ESP® control unit (N30/4).
Do not handle the electrical connector (1) at the bracket (2) when doing so. Otherwise the bracket (2) will be damaged.
- Swing bracket (2) downwards until it locks in place and push lock (3) back over release (4).
Connect electrical connector (1)
- Push lock (3) upwards (arrow) until the release (4) is exposed.
- Press release (4), hold down, and swing bracket (2) upwards to the end stop.
- Push electrical connector (1) onto jack in the ESP® control unit (N30/4) until it makes contact evenly along its entire length.
Do not handle the electrical connector (1) at the bracket (2) when doing so. Otherwise the bracket (2) will be damaged.
- Swing bracket (2) downwards until it locks in place and push lock (3) back over release (4).
This pulls the electrical connector (1) into its final position and locks it.