Wiring Diagram For Battery Management Control Unit - PE54.10-P-2104-97FBA
Model 205 up to model year 2019 with code ME04 (Mild hybrid drive) except code ME06 (Hybrid drive 60 kW variant (incl. plugin)) Control unit N82/2
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Use of wiring diagrams | 32L |
| A100 | High-voltage battery module | 28A |
| A100n1 | High-voltage on-board electrical system insulation monitoring control unit | 27B |
| A100s1 | Contactor | 28B |
| A100s2 | Contactor | 28B |
| A9/5 | Electric refrigerant compressor | 19L |
| CAN L | Hybrid CAN | 12K |
| F34/6 | High-voltage distributor plate | 24J |
| F63 | Pyrofuse | 8L |
| K40/5 | Rear fuse and relay module | 5L |
| K40/5f412 | Fuse 412 | 3L |
| K40/5f457 | Fuse 457 | 4L |
| N129/1 | Power electronics control unit | 15L |
| N129/1 | Power electronics control unit | 26L |
| N82/2 | Battery management system control unit | 4A |
| N82/2 | Battery management system control unit | 12A |
| N82/2 | Battery management system control unit | 20A |
| W52/5 | Left center longitudinal member ground point | 11H |
| W52/7 | Left rear longitudinal member ground point | 23F |
| W6 | Left wheel arch trunk ground point | 9H |
| X18 | Cockpit wiring harness and frame floor assembly electrical connector | 7H |
| X217/1 | Battery management system electrical connector | 2F |
| X25/7 | Engine compartment/frame floor assembly electrical connector | 19H |
| X30/44 | Hybrid CAN (CAN L) potential distributor electrical connector | 12L |
| Y19/1 | High-voltage battery cooling system shutoff valve | 22L |