Retrofit Electrical Wiring Harness For CA Module Card Reader - AZ82.60-P-0032-01LW

Model 205.0 (except 205.047) 

Model 205.2/3 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on sensor system for trunk lid opening/closing		AH80.61-P-0001-01A

1. Connect blue 1-pin connector (5.1) at tuner unit (A90/4).
2. Route wiring harness (5) along existing lines to CA Module Card reader installation location.

   Note extended length of wiring harness (5) for connection at CA Module Card reader.

   Blue 1-pin connector (5.2) is connected to CA Module Card reader at a later point in time.

   Courtesy of MERCEDES-BENZ USA