Remove/Install Trim At C-Pillar - AR68.30-P-4490LW

MODEL 205.0/1 

Fig 1: Trim At C-Pillar Components Location - Model 205.0; Shown On Right Side Of Vehicle

Courtesy of MERCEDES-BENZ USA

Shown on right side of vehicle 

	Remove/install
1	Remove seat cushion in the rear	MODEL 205.0/1 without CODE 248 (Rear seat with integrated child seat) without CODE P10 (Taxi package Germany)	AR91.12-P-1020LW
		MODEL 205.0/1 with CODE 248 (Rear seat with integrated child seat) MODEL 205.0 with CODE P10 (Taxi package Germany)	AR91.12-P-1020LWA
2	Remove edge guard (2) in area of C-pillar paneling (1)
3	Unscrew bolt (3)	Screw/bolt, rear belt end fitting	*BA91.40-P-1005-01U
4	Unclip cover (4)	Retaining clip remains in C-pillar paneling (1). Clip remover	Fig 2
5	Detach C-pillar paneling (1) from C-pillar, slightly tilt toward center of vehicle and then move out toward front	Carefully remove C-pillar paneling (1). Otherwise the headliner (5) can be damaged. Insert cover (4) into retaining clips on C-pillar paneling (1). Clip in C-pillar paneling (1) completely preassembled. Ensure that C-pillar paneling (1) is seated correctly.
6	Guide seat belt (6) through C-pillar paneling (1)
7	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		MODEL 205.0	MODEL 205.1
BA91.40-P-1005-01U	Screw/bolt, rear belt end fitting	Nm	35	35

Fig 2: Identifying Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA