LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> C300 Base, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Electrical System - Body - 205 Chassis 1 Of 6 >> Basic Knowledge >> Actuate Turn Signal Light, Basic Function - GF82.10-P-1023A

Actuate Turn Signal Light, Basic Function - GF82.10-P-1023A

Model all (CAR) 

Overview 

This service information contains the following information:

General 

Turn signal light actuation comprises all functions for output of the turn signal, various warnings and feedback.

The various requests to output the function are prioritized by the exterior lighting control unit (dependent on vehicle either the central signal acquisition and actuation module or the front signal acquisition and actuation module). Turn signaling can be overridden by the hazard warning flasher function, and vice versa. The exterior lighting control unit sends a flasher frequency with the time period for the bright phase of the turn signal lights over CAN to the corresponding control units. The respective active function is indicated by indicator lamps and also signaled acoustically.

If a turn signal light fails, the frequency at which the indicator lamps are actuated is doubled, as is the frequency of the acoustic feedback. The flashing frequency of the turn signal lights of 1.5 Hz remains the same.

Economic Commission for Europe (ECE) vehicles 

During turn signal light actuation, the daytime running lights are switched off.

Canada version or USA version 

During turn signal light actuation, the daytime running lights are dimmed to position light level.

Turn signals 

The turn signaling indicates the vehicle's intended direction of travel.

Function requirement 

Operating principle 

Pressing the combination switch downwards or upwards requests turn signaling in the corresponding direction.

If the combination switch is only operated briefly (under 440 ms), three blinking cycles are output (one-touch turn signaling).

On vehicles with Active Parking Assist, the system requests turn signaling during the assisted parking procedure.

IMPORTANT The one-touch turn signaling is overridden by the hazard warning flasher or canceled if the combination switch is activated in the opposite direction.

Vehicles with trailer hitch 

During trailer operation, the turn signal light on the trailer is also actuated. The exterior lighting control unit requests actuation of the turn signal lights on the trailer. The trailer recognition control unit implements this request.

Hazard warning flashing 

During hazard warning flashing, all turn signal lights on the vehicle are actuated synchronously. Depending on the ignition status, two duty cycles are output.

Function requirement 

IMPORTANT If a turn signal light fails during hazard warning flashing, the frequency at which the indicator lamps are actuated doubles. The frequency of the acoustic feedback is not doubled.

Hazard warning flashing can be triggered manually via the hazard warning lights button.

Hazard warning flashing after maximum full-stop braking (not for Canada version or USA version) 

If the vehicle was decelerated by maximum full-stop braking from a speed of at least 70 km/h to less than 3 km/h, the hazard warning flashers are automatically activated. The hazard warning flasher is deactivated by pressing the hazard warning lights button or upon exceeding a speed of 10 km/h.

Hazard warning flashing after emergency stop (vehicles with Driving Assistance Package) 

If the vehicle is decelerated below the speed of 60 km/h due to an emergency stop, the hazard warning flasher is automatically activated. As long as the vehicle is not decelerated below 3 km/h, the hazard warning flasher is also switched off when the emergency stop is over. The hazard warning flasher continues to operate below 3 km/h.

The hazard warning flasher is deactivated by pressing the hazard warning lights button or upon exceeding a speed of 10 km/h.

The hazard warning flasher during emergency stop function is not available in the following countries:

Hazard warning flashing after airbag deployment 

When an airbag is deployed or during a rollover of the vehicle (crash signal sent), the hazard warning flasher is automatically activated. The hazard warning flasher is deactivated by pressing the hazard warning lights button.

CL locking/unlocking feedback 

The hazard warning flasher is automatically activated when the CL is locked/unlocked. When the CL is unlocked, the hazard warning flashing function is activated for one blinking cycle; three blinking cycles are output when it is locked.

Hazard warning flashing for alarm (vehicles with ATA) 

The hazard warning flasher is automatically activated when an ATA or emergency alarm is triggered.

  Function schematics     
  Function schematic, turn signaling Model 118, 177, 243, 247 PE82.10-P-2509-97A
    Model 167, 293 PE82.10-P-2509-97B
    Model 206, 232, 295, 297 PE82.10-P-2509-97C
    Model 213, 238, 257, 290 as of model year 2021 PE82.10-P-2509-97D
    Model 223 PE82.10-P-2509-97E
  Function schematic, hazard warning flashing Model 118, 177, 243, 247 PE82.10-P-2511-97A
    Model 167 Model 293 PE82.10-P-2511-97B
    Model 206, 232, 295, 297 PE82.10-P-2511-97C
    Model 213, 238, 257, 290 as of model year 2021 PE82.10-P-2511-97D
  Control units     
  Trailer recognition control unit, basic function Model all (CAR) with code 550 (Trailer coupling) GF31.19-P-9890A
  Basic function of signal acquisition and actuation module Model 118, 177, 243, 247 GF54.21-P-9895A
  Basic function of signal acquisition and actuation module at front Model 167, 206, 223, 232, 297
Model 213, 238, 257, 290
as of model year 2021		 GF54.21-P-9896A
  Front door control unit, basic function   GF72.29-P-9891A
  Headlamp control unit, basic function Model all (CAR)
with code 316 (Digital LED headlamps, SAE right-hand traffic)
Model all (CAR)
with code 317 (Digital LED headlamps, left-hand traffic)
Model all (CAR)
with code 318 (Digital LED headlamps, right-hand traffic)
Model all (CAR)
with code 631 (Static LED headlamps, left-hand traffic)
Model all (CAR)
with code 632 (Headlamps, LED, static, right-side traffic)
Model all (CAR)
with code 640 (SAE dynamic LED headlamps, right-hand traffic)
Model all (CAR)
with code 641 (Dynamic LED headlamps, left-hand traffic)
Model all (CAR)
with code 642 (Dynamic LED headlamps, right-hand traffic)		 GF82.10-P-9890A 
  Components     
  Front lamp unit, basic function   GF82.10-P-2000A
  Rear lamp unit, basic function   GF82.10-P-2004A
scientia non olet · About LEMON Manuals