Prepare Panoramic Sliding Roof Frame For Installation - AR77.21-P-0801-02MFA
Model 118, 177
with code 413 (Automatic panoramic sliding sunroof)
| Topical note | Notes on removal/installation of bonded elements of panoramic roof | AH77.21-P-0001-01A |
TEST AND ADJUSTMENT VALUES FOR WINDSHIELD
| Number | Designation | Model 118 | Model 177 | ||
|---|---|---|---|---|---|
| BE67.10-P-1001-02C | Distance between top edge of window and front edge of roof/sliding roof aperture panel | Dimension "A" | mm | 2, 5 (± 1) | 2, 5 (± 1) |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1062-02A | Adhesive fabric tape | A 007 989 28 85 |
- Place panoramic sliding sunroof frame (1) onto suitable base with inside pointing upward.
- Cut down residual adhesive beads (2) on panoramic sliding sunroof frame (1) to a remaining height of approx. 1 to 2 mm using a scraper.
If the panoramic sliding sunroof frame (1) is to be reused.
- Remove residues of spacers (3) completely.
If the panoramic sliding sunroof frame (1) is to be reused.
- Clean panoramic sliding sunroof frame (1).
If the panoramic sliding sunroof frame (1) is to be reused.
Commercially available devices/tools
Wet and dry vacuum cleaner
- Clean bonding surfaces on panoramic sliding roof frame (1).
- Install new spacers (3) as shown.
- Place panoramic sliding sunroof frame (1) onto body and use the
feeler gauge to align the distance between the top edge of the window and the roof front edge/sliding roof frame.
- Affix the strips of adhesive tape and cut through at the outer edges of the panoramic sliding sunroof frame (1).
- Place panoramic sliding sunroof frame (1) onto suitable base with inside pointing upward.
- Apply activator to bonding surfaces on panoramic sliding roof frame (1).