LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> A35 AMG >> Repair and Diagnosis >> Body & Frame >> Mirrors >> Interior Equipment - 177 Chassis >> Testing & Repair >> Remove/Install Side Paneling In Rear >> Remove/Install Side Paneling In Rear - AR68.30-P-4780MFV

Remove/Install Side Paneling In Rear - AR68.30-P-4780MFV

Model 118.3/6, 177.1/9, 247.0/7 

MODIFICATION NOTES

09.12.2019 Remove corresponding seats in the rear passenger compartment. Operation step 2.2.  
G15492187Courtesy of MERCEDES-BENZ USA

Shown on model 177.1 

WARNING Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
REMOVINGINSTALLING Remove/install     
1 Remove C-pillar trim. Model 118.6  
    Model 118.3, 177.1/9 AR68.30-P-4490MFV 
    Model 247.0/7 AR68.30-P-4490MFB
2.1 Remove seat backrest in rear. Model 118.3/6, 177.1/9
Model 247.0/7
except code 567 (Vario rear seat)
 
    Model 118.3, 177.1/9
except code 287 (Folding seat backrests in rear passenger compartment)
AR91.12-P-1713MFV
    Model 118.3/6, 177.1
with code 287 (Folding seat backrests in rear passenger compartment)
Model 247.0/7
except code 567 (Vario rear seat)
AR91.12-P-1713MFA
2.2 Remove corresponding seats in the rear passenger compartment. Model 247.0/7
with code 567 (Vario rear seat)
 
      AR91.12-P-4026MFX
3 Remove tie-down eye (4). TORQUE SPECIFICATION Screw/bolt for tie-down eye *BA68.50-P-1001-03I 
4 Remove load compartment floor from trunk.    
5.1 Remove nuts (5) and remove mounting support (6). Model 118.3/6, 177.1/9  
5.2 Remove the fastening bracket (6) for the load compartment floor. Model 247.0/7  
6 Release trim at side in trunk until retaining clips (1) can be accessed. Model 247.0/7 AR68.30-P-4800MFB
    Model 118.3, 177.1/9 AR68.30-P-4800MFV 
7 Carefully loosen the side paneling (2) on the retaining clips (1) and retaining clamps (3) and remove. INSTALLATION IMPORTANT Replace damaged retaining clips (1) and retaining clamps (3).
Ensure that the edge guard is seated correctly in the working area.
 
8 Install in the reverse order. SPECIAL TOOL Dismantling tool Fig 1
CARGO RETAINERS

Number Designation Model 118 Model 177, 247
BA68.50-P-1001-03I Screw/bolt for tie-down eye Nm 24 24
Fig 1: Identifying Dismantling Tool (000 589 95 63 00)
G12619044Courtesy of MERCEDES-BENZ USA