Remove/Install C-Pillar Trim Sections - AR68.30-P-4491MFA

Model 177.0 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Move driver's seat or front passenger seat forward
2	Switch off ignition and store transmitter key outside of transmission range (min. 2 m)
3	Fold forward left or right rear seat
4	Remove rear shelf
5	Remove edge guard in working area of left or right rear door and trunk	Ensure that edge guard is correctly seated.
6	Unclip cover (2)
7	Unclip trunk lamp (3) and release and disconnect electrical connector
8	Unclip and remove C-pillar trim (1)	Ensure that retaining clips (4) and fixing clips (5) correctly engage. Slide trim (6) under C-pillar trim (1).
		Long wedge	Fig 1
9	Install in the reverse order

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA