Remove/Install Instrument Cluster Control Unit - AR54.30-P-7101MFA
Model 118, 177, 247
with code 547 (Connect 20 Entry (NTG6))
Model 118, 177, 247
with code 548 (Connect 20 MID (NTG6))
Model 118, 177, 247
with code 549 (Connect 20 HIGH (NTG6))
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Commission instrument cluster control unit (N133/1). | If the instrument cluster control unit (N133/1) is replaced. | |
| AD00.00-P-2000-06MFA | |||
| 2 | Remove door sill at front left. | AR68.30-P-4101MFA | |
| 3 | Release left front seat, tilt backward and place onto rear bench seat. | AR91.10-P-1000MFA | |
| 4 | Fold front left floor covering (1) forward. | ||
| 5 | Lift up air duct (3) and left rear floor covering (2). | ||
| 6 | Remove nuts(4). | ||
| 7 | Carefully remove holder (5) and turn over with connected electric lines. | Do not crush or kink or subject electric lines to tension. This will result in damage to the electric lines and can impair their function. |
|
| 8 | Release and disconnect electrical connectors from instrument cluster control unit (N133/1). | ||
| 9 | Unscrew nuts (6) and remove instrument cluster control unit (N133/1). | ||
| 10 | Install in the reverse order. |