Remove/Install Low-Temperature Circuit Coolant Expansion Reservoir Carrier - AR09.41-P-0007RKA
ENGINE 276.8 in model 172
ENGINE 276.8 in model 231
Fig 1: Low-Temperature Circuit Coolant Expansion Reservoir Carrier Components Location - Engine 276.8 In Model 172
| Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. |
AS20.00-Z-0001-01A | |
| Notes on coolant | AH20.00-N-2080-01A | ||
| Remove/install | |||
| 1 | Remove low-temperature circuit expansion reservoir | AR09.41-P-0001RKA | |
| 2 | Detach boost pressure control pressure transducer and place with attached lines to one side | AR07.17-P-7002RKA | |
| 3 | Remove screw/bolt (1) | ||
| 4 | Unclip electrical line (2) from carrier (7) | ||
| 5 | Unclip bracket (3) from carrier (7) | ||
| 6 | Detach electrical line (4) from carrier (7) | ||
| 7 | Unclip electrical line of boost pressure control pressure transducer on carrier (7) | ||
| 8 | Unclip engine cable harness on carrier (7) | ||
| 9 | Remove screw/bolts (6) | *BA20.10-P-1009-01AA | |
| *BA20.10-P-1010-01AA | |||
| 10 | Remove carrier (7) | ||
| 11 | Install in the reverse order |
COOLANT PUMP, COOLANT THERMOSTAT
| Number | Designation | ENGINE 276 | |
|---|---|---|---|
| BA20.10-P-1009-01AA | Bolt, bracket for expansion reservoir to cylinder head cover | Nm | 9 |
COOLANT PUMP, COOLANT THERMOSTAT
| Number | Designation | ENGINE 276 | |
|---|---|---|---|
| BA20.10-P-1010-01AA | Bolt, bracket for expansion reservoir to cylinder head | Nm | 9 |