Retrofit Universal Media Interface Adapter Wiring Harness - AZ82.85-P-0004-02W

MODEL 172.### 1# 

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Connection scheme 

Courtesy of MERCEDES-BENZ USA

Routing diagram 

Courtesy of MERCEDES-BENZ USA

1. Wrap felt tape around branch-off line of center instrument panel speaker (a) of the Universal Media Interface adapter wiring harness (3).

   Courtesy of MERCEDES-BENZ USA

2. Connect black 44-pin plug (6) of Universal Media Interface adapter wiring harness (3) to black 44-pin coupling (7) of vehicle wiring harness.
3. Remove black, 2-pin coupling for optical fiber (11) from black, 44-pin coupling (7), and install in black, 44-pin coupling (4).

   Only for vehicles with  one of the following codes:

   • Code (518) Media interface
   • Code (810) Sound system
4. Route Universal Media Interface adapter wiring harness (3) to left lower radio recess.

   Courtesy of MERCEDES-BENZ USA

   The black, 44-pin coupling (4) is connected to the radio at a later stage. The Universal Media Interface adapter wiring harness (3) obstructs the installation of the radio because of its size.

   The radio can only be installed if the Universal Media Interface adapter wiring harness (3) is as low down as possible in the rear area of the radio recess.

5. Route white, 32-pin coupling (5) of Universal Media Interface adapter wiring harness (3) into the front passenger footwell.

   The white, 32-pin coupling (5) is connected to the Universal Media Interface control unit at a later stage.

   Courtesy of MERCEDES-BENZ USA

6. Unclip covering of instrument panel center speaker (H4/27) carefully using long wedge.
7. Remove covering of instrument panel center speaker (H4/27).
8. Unclip center instrument panel speaker (H4/27)

   On vehicles with  code (810) Sound system.

9. Route black 2-pin plug (10) and black 2-pin coupling (9) of Universal Media Interface adapter wiring harness (3) to installation location of instrument panel center speaker as shown.

   Courtesy of MERCEDES-BENZ USA

10. Detach black, 2-pin coupling (8) from center instrument panel speaker (H4/27).

    On vehicles with  code (810) Sound system.

11. Route black 2-pin plug (10) and black 2-pin coupling (9) of Universal Media Interface adapter wiring harness (3) out of opening at the instrument panel.
12. 1. 12.1 Connect black 2-pin plug (10) to black 2-pin coupling (8) of vehicle wiring harness.

       On vehicles with  code (810) Sound system.

    2. 12.2 Strap down black 2-pin plug (10) to branch-off line of Universal Media Interface adapter wiring harness (3) and wrap with felt tape.

       In vehicles without  code (810) Sound system.

       Courtesy of MERCEDES-BENZ USA

13. Connect black 2-pin coupling (9) to instrument panel center speaker (H4/27).
14. Clip in center instrument panel speaker (H4/27)

    For vehicles without  code (810) Sound system, the instrument panel center speaker (H4/27) has to be retrofitted.

15. Install covering of instrument panel center speaker (H4/27).

Courtesy of MERCEDES-BENZ USA