Install Illuminated Door Sill - AN82.20-P-0001-04W

MODEL 172.4## 

(except 172.475) 1# 

Installation is shown on the right side of vehicle, installation on the left side of vehicle is performed in the same manner.

1. Clean contact surface of door sill in hatched area (A).

   Courtesy of MERCEDES-BENZ USA

2. Detach protective foil (4) from right illuminated door sill molding (E17/36).

   Courtesy of MERCEDES-BENZ USA

3. Hook right illuminated door sill molding (E17/36) into longitudinal member panel (13), align and then clip permanently into place.

   When installing the right illuminated door sill molding (E17/36) make sure that the electrical line (6) is not twisted or pinched.

4. Route electrical line (6) over the longitudinal member and fasten in place, as shown using felt tape (7).

The plug (5.2) will be connected at a later stage with the coupling of the wiring harness for the illuminated door sill molding.

Courtesy of MERCEDES-BENZ USA