Remove/install wiper system - AR82.30-P-6400RK
MODEL 231
| Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism. | When working on the windshield wiper mechanism, always switch off the ignition and store transmitter key outside of transmission range (at least 2 m). | AS82.30-Z-0001-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch on ignition and store transmitter key outside of transmission range (min. 2 m) | ||
| 2 | Remove air-water duct | AR83.25-P-1402RK | |
| 3 | Remove bolts (2) | ||
| 4 | Remove diagonal strut (6) | ||
| 5 | Unscrew nuts (1) | *BA82.30-P-1003-01M | |
| 6 | Remove screw (5) | *BA82.30-P-1004-01M | |
| 7 | Unscrew screw/bolt (7) | ||
| 8 | Remove connector box (4) from windshield wiper system (3) and place to one side with lines connected | ||
| 9 | Remove windshield wiper system (3) until electrical connector (8) is accessible | ||
| 10 | Disconnect electrical connection (8) | ||
| 11 | Remove windshield wiper system (3) | ||
| 12 | Install in the reverse order | ||
| Check | |||
| 13 | Check wiper arms and adjust | AR82.30-P-6000LC |
WINDSHIELD WIPER
| Number | Designation | Model 231 | |
|---|---|---|---|
| BA82.30-P-1003-01M | Nut, windshield wiper system to body | Nm | 11 |
WINDSHIELD WIPER
| Number | Designation | Model 231 | |
|---|---|---|---|
| BA82.30-P-1004-01M | Screw/bolt, windshield wiper system bracket to partition wall | Nm | 11 |