Remove/install upper tank cover - AR64.20-P-1080RK

MODEL 231 

Fig 1: Upper Tank Cover Remove/Install Components (1 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 2: Upper Tank Cover Remove/Install Components (2 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 3: Upper Tank Cover Remove/Install Components (3 Of 3)

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Notes on sensor system for trunk lid opening/closing		AH80.61-P-0001-01A
	Remove/install
1	Open Vario roof
2	Switch off ignition and remove transmitter key (A8/1) or KEYLESS-GO start/stop button (S2/3) from electronic ignition lock control unit (N73)	KEYLESS-GO start/stop button (S2/3) only with code (889) KEYLESS-GO.
3	Remove interior compartment paneling from roll bar (2)		AR68.30-P-1380RK
4	Unscrew bolts (3) at top from tank cover (4)
5	Close Vario roof
6	Remove trims in trunk		AR68.30-P-4600RK
7	Remove tank cover (4) together with consoles (5)	For this purpose unscrew bolts (6) at bottom from tank cover (4)
8	Install in the reverse order