Remove/install complete outside mirror - AR88.70-P-9000LFS
MODEL 222 with CODE Z07 (Top protection)
MODIFICATION NOTES
| 28.8.15 | "Specifications on calibrating 360° camera" added. | Operation step 9 | |
| 10.9.15 | "Check outside mirror for proper function" added. | Operation step 10 |
Shown on left side of vehicle
Shown on right side of vehicle
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove mirror triangle paneling (9) on left and right front door (7) | Figure | |
| 2 | Remove door trim (2) from front door (7) | AR72.10-P-1000LF | |
| 3 | Secure mirror triangle armor plate (11) against falling down | ||
| 4 | Unscrew bolts (12) from front door (7) and remove mirror triangle armor plate (11) | *BA72.10-P-1009-01Y | |
| 5 | Disconnect electrical connectors (3, 4) from front door control unit (5) | ||
| 6 | Unscrew bolts (6) and remove outside mirror (1) from front door (7) | ||
| 7 | Unclip electrical wiring harness (8) from bracket (10) and guide through passage (arrow) | ||
| 8 | Install in the reverse order | ||
| 9.1 | Calibrate 360° camera on left or right outside mirror (1) with diagnostic system | Model 222 with code 501 (360° camera) with code Z07 (Top protection) If the left or right outside mirror (1) has been removed. |
|
| AD00.00-P-2000-04B | |||
| 9.2 | Calibrate all the cameras for the 360° camera system using the diagnostic system | Model 222 with code 501 (360° camera) with code Z07 (Top protection) If the left or right outside mirror (1) has been removed. |
|
| AD00.00-P-2000-04B | |||
| Check | |||
| 10 | Check outside mirror (1) for proper function |
FRONT DOOR
| Number | Designation | Model 222 with CODE Z07 | ||
|---|---|---|---|---|
| BA72.10-P-1009-01Y | Bolt, armor plate to front door | M6 | Nm | 8 |
| M8 | Nm | 25 | ||