Remove/install side window roller blind - AR72.12-P-2000LFS

MODEL 222 with CODE Z07 (Top protection) 

Fig 1: Side Window Roller Blind Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove door lining from left or right rear door	MODEL 222.1 with CODE Z07 (Top protection)	AR72.12-P-1010LF
2	Remove left and right window frame paneling	Always replace window frame paneling.
		Mounting wedge	Figure
3	Disconnect electrical connector (4) from left rear door control unit or right rear door control unit and expose electrical wiring harness
4	Unclip left cable guide (5)	Clip remover	Figure
5	Cut cable tie from right cable guide (6)
6	Remove bolts (8)
7	Unscrew nut (9) and nuts (10)
8	Remove bolts (11)	Bolt, roller sun blind to rear door	*BA72.12-P-1010-01S
9	Remove roller blind for side window (1)
10	Install in the reverse order

REAR DOOR

Number	Designation			Model 222 with CODE Z07
BA72.12-P-1010-01S	Bolt, roller sun blind to rear door	M5	Nm	4
		M6	Nm	8

Fig 2: Identifying Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA