Remove, Replace And Install Rear Center Seat Belt - AR91.40-P-0683LF

Model 222.0/1/9 except code 224 (Individual rear seats) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury.  Injury may result when the tension in the spring in the automatic belt retractor is released.	Never disassemble automatic belt retractors.	AS91.00-Z-0002-01A
	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Remove/install
1	Remove rear shelf	Remove rear shelf only until belt retractor (3) can be removed.	AR68.30-P-4580LF
2	Unscrew nut (7)	Model 222.0/1 with code P36 (PRE-SAFE® rear package) except code 224 (Individual rear seats) Bolt/nut for rear belt buckle	*BA91.40-P-1008-01T
3	Unscrew bolt (4)	Model 222.0/1 except code 224 (Individual rear seats) except code P36 (PRE-SAFE® rear package) Bolt/nut for rear belt buckle	*BA91.40-P-1008-01T
4	Expose and disconnect electrical connector of electrical line (6)	Model 222.0/1 except code 224 (Individual rear seats) except code P36 (PRE-SAFE® rear package)
5	Remove belt buckle (5)	Model 222.0/1 except code 224 (Individual rear seats) except code P36 (PRE-SAFE® rear package)
6	Unscrew nut (2)	Nut, rear belt retractor to rear panel crossmember (rear shelf)	*BA91.40-P-1010-01T
7	Remove belt retractor (3) with seat belt (1)	Pay attention to the installation position of the seat belt (1).
8	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Model 222
BA91.40-P-1008-01T	Bolt/nut for rear belt buckle	Nm	35

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Model 222
BA91.40-P-1010-01T	Nut, rear belt retractor to rear panel crossmember (rear shelf)	Nm	35