Remove/Install Seal For Side Window On Front Door - AR72.10-P-1906LFS
Model 222
with code Z07 (B7 armoring on special protection version)
with code Z11 (Left front power window with special protection)
with code Z12 (Right front power window with special protection)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Remove side window in front door | AR72.10-P-1961LFS | |
| 2 | Remove outside mirror completely | AR88.70-P-9000LFS | |
| 3 | Remove outside mirror seal from front door (6) | ||
| 4 | Position adhesive strip below both ends of outer sealing rail (4) and glue to door paneling | Adhesive strips protects painting. Otherwise the paint can be damaged when removing the outer sealing rail (4). |
|
| 5 | Remove outer sealing rail (4) | Carefully lift outer sealing rail (4) out of bead on door paneling. Otherwise the outer sealing rail (4) can bend and must be replaced. |
|
| Fig 1 | |||
| 6 | Remove trim piece (2) | Carefully lift trim piece (2) out of side window seal (1). Otherwise the trim piece (2) can bend and must be replaced. |
|
| Fig 1 | |||
| 7 | Remove window frame paneling (7) | ||
| 8 | Remove inner sealing rail (8) | Carefully lift inner sealing rail (8) out of bead on inner door panel. Otherwise the inner sealing rail (8) can deform and must be replaced. |
|
| Fig 1 | |||
| 9 | Pull out side window seal (1) in area of B-pillar cover (3) | ||
| 10 | Pull out side window seal (1) in area of outer outside mirror | ||
| 11 | Unscrew bolts (9) from B-pillar cover (3) | ||
| 12 | Remove B-pillar cover (3) | ||
| 13 | Remove side window (1) from front door window frame (6) | Ensure that side window seal (1) is seated correctly. Otherwise leakage can occur. |
|
| 14 | Install in the reverse order |