Remove/Install Rear Seat Belts - AR91.40-P-0681LF

Model 222.0/1 except code 223 (Electric backrest adjustment and head restraints) except code 224 (Individual rear seats) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  during testing and repair operations related to pyrotechnically components	Do not expose pyrotechnically component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts.	AS91.00-Z-0008-01A
	Risk of injury.  Injury may result when the tension in the spring in the automatic belt retractor is released.	Never disassemble automatic belt retractors.	AS91.00-Z-0002-01A
Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
Notice	Notes on performing repair, body work and welding on vehicles with airbags and RTE units		AH91.00-P-0002-01M
	Information, assessment and legal requirements when working with, handling and storing pyrotechnically components		AH91.00-Z-0000-10A
	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Remove/install
1	Remove seat cushion (2)		AR91.12-P-1020LF
2	Disconnect battery ground line		AR54.10-P-0003LF
3	Remove C-pillar trim (3)		AR68.30-P-4490LF
4	Remove covers for C-pillar seat belts (4) from seat belts (1)	When replacing the seat belts (1) with belt retractors (6).
5	Disconnect electrical connections (5)
6	Fold soundproofing (7) backwards
7	Remove screws/bolts (8)	Bolt, rear seat belt retractor	*BA91.40-P-1009-01T
8	Remove screw/bolts (9)	Bolt/nut for rear belt end fitting	*BA91.40-P-1011-01T
9	Remove seat belts (1) with belt retractors (6)	If belt retractors (6) are replaced, the defective belt retractors (6) must be properly disposed of. Note installation position of the seat belts (1).
10	Install in the reverse order
11	Connect diagnostic system and check supplemental restraint system (SRS)
			AD00.00-P-2000-04B