Wiring Diagram For 360° Camera Control Unit - PE54.65-P-2104-97SEA
Model 217 up to model year 2018 with code 501 (360° camera) Control unit N148
Model 222 up to model year 2018 with code 501 (360° camera) Control unit N148
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Use of wiring diagrams | 32L |
| A40/3 | COMAND control unit | 12L |
| B84/10 | Rear end 360° camera | 25L |
| B84/7 | Left outside mirror 360° camera | 22L |
| B84/8 | Right outside mirror 360° camera | 28L |
| B84/9 | Front end 360° camera | 17L |
| CAN HMI | User interface CAN | 7K |
| K40/5 | Rear fuse and relay module | 3L |
| K40/5f409 | Fuse 409 | 2L |
| N148 | 360° camera control unit | 4A |
| N148 | 360° camera control unit | 11A |
| N148 | 360° camera control unit | 20A |
| N148 | 360° camera control unit | 28A |
| U1217 | Valid for model series 217 | 10D |
| U1217 | Valid for model series 217 | 17D |
| U1222 | Valid for model series 222 | 10D |
| U1222 | Valid for model series 222 | 14D |
| U1222 | Valid for model series 222 | 2D |
| U413 | Valid for model 217.3 | 2D |
| U414 | Valid for model 217.4 | 4D |
| W54/3 | Left rear wheel well ground point | 4G |
| W6/1 | Left tail lamp trunk ground point | 3G |
| X141/4 | Left outside mirror 360° camera electrical connector | 21H |
| X141/5 | Right outside mirror 360° camera electrical connector | 27H |
| X18/35 | Cockpit wiring harness and frame floor assembly electrical connector | 7E |
| X233/1 | Front end 360° camera electrical connector | 18H |
| X30/20 | User interface CAN (CAN HMI) potential distributor electrical connector | 7L |
| X35/1 | Left front door electrical connector | 21E |
| X35/2 | Right front door electrical connector | 27E |