LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2020 >> S560e >> Repair and Diagnosis >> Accessories & Equipment >> Anti-Theft Systems >> Doors - 222 Chassis (1 Of 2) >> Testing & Repair >> Remove/Install Rear Door >> Remove/Install Rear Door - AR72.12-P-0600LFS

Remove/Install Rear Door - AR72.12-P-0600LFS

Model 222 

with code Z07 (B7 armoring on special protection version) 

G15380300Courtesy of MERCEDES-BENZ USA
WARNING Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
Topical note  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVINGINSTALLING Remove     
1.1 Remove window on left or right rear door Model 222
with code Z07 (B7 armoring on special protection version)
with code Z13 (Left rear power window with special protection)
with code Z14 (Right rear power window with special protection)
 
      AR72.12-P-1920LFS 
1.2 Remove window on left or right rear door Model 222
with code Z07 (B7 armoring on special protection version)
except code Z13 (Left rear power window with special protection)
except code Z14 (Right rear power window with special protection)
 
2 Disconnect battery ground line   AR54.10-P-0003LF
3 Disconnect electrical connector on left rear door (5) or electrical connector on right rear door    
4 Press left door holder (2) or right door holder off of ball stud on B-pillar SPECIAL TOOL Mounting wedge Fig 1
5 Remove caps from bolts (4)    
6 Remove screws (4)    
7 Remove rear door (1) from door hinge halves on B-pillar NOTES
Remove rear door (1) carefully.
Otherwise the rear door (1) and front door can be damaged.
 
INSTALLING Install     
8 Position rear door (1) on door hinge leaf on B-pillar    
9 Moisten thread on bolts (4) with Loctite Thread locking agent, Loctite 243 (10 ml) *BR00.45-Z-1133-02A 
10 Tighten bolts (4) TORQUE SPECIFICATION Bolt to hinge shaft *BA72.12-P-1003-01S 
11 Repair paint damage in area of bolts (4)    
12 Install caps on bolts (4)    
13 Press left door holder or right door holder on ball stud to B-pillar    
14 Connect electrical connector on left rear door (5) or electrical connector on right rear door    
15 Connect ground cable to battery   AR54.10-P-0003LF
16.1 Remove window on left or right rear door Model 222
with code Z07 (B7 armoring on special protection version)
except code Z13 (Left rear power window with special protection)
except code Z14 (Right rear power window with special protection)
 
16.2 Remove window on left or right rear door Model 222
with code Z07 (B7 armoring on special protection version)
with code Z13 (Left rear power window with special protection)
with code Z14 (Right rear power window with special protection)
 
      AR72.12-P-1920LFS 
INSPECT Check     
17 Check adjustment of rear door (1), correct if necessary   AR72.12-P-0650LFS 
REAR DOOR

Number Designation MODEL 222 with CODE Z07
BA72.12-P-1003-01S Bolt to hinge shaft Nm 34
Fig 1: Identifying Mounting Wedge (110 589 03 59 00)
G11128978Courtesy of MERCEDES-BENZ USA
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1133-02A Thread locking agent, Loctite 243 (10 ml) A 613 989 09 71 09