Remove/Install Rear Seat Backrest - AR91.12-P-1620LFA

Model 222.0/1/9 

with code 223 (Electric backrest adjustment and head restraints) 

Model 222.0/1/9 

with code 224 (Individual rear seats) 

Shown on left side of vehicle 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Shown on left side of vehicle 

Courtesy of MERCEDES-BENZ USA

Shown on left side of vehicle 

	Remove/install
1	Remove seat cushion (2)		AR91.12-P-1020LFA
2	Remove outer belt guide (4) from seat backrest (1) and place outer seat belt (5) to one side	Press outer belt guide (4) in pivot point (arrow E) up to end stop in the backrest (1), then rotate through 90° to one side and pull upwards out of the backrest (1). Outer belt guide (4) remains on outer seat belt (5).
3	Remove center belt guide (3) from backrest (1) and place center seat belt (6) to one side	When removing left backrest (1). H Press center belt guide (3) in pivot point (arrow D) up to end stop in backrest (1), then rotate through 90° to one side and remove upwards out of backrest (1). Center belt guide (3) remains on center seat belt (6).
4	Remove belt buckle screw/bolt (7)	:  Ensure that belt buckle (8) is seated correctly. Pay attention to the correct installation position of the center seat belt (6).
		Bolt/nut for rear belt buckle	*BA91.40-P-1008-01T
5	Remove screw/bolts (9, 10)	Bolt, backrest to body	*BA91.12-P-1003-03L
6	Fold backrest (1) forward
7	Fold up cover (12)
8	Fold over damping material (13)
9	Disconnect electrical connectors (14, 15)	The number of electrical connectors (14, 15) differs depending on the vehicle equipment.
10	Remove backrest (1) from vehicle	Carefully remove backrest (1) from vehicle. Otherwise components of the vehicle may be damaged.
11	Install in the reverse order