Remove/Install Left Front Engine Support - AR22.10-P-4325MNL

Engine 176 in model 217, 222 

except code M005 (Vehicles with 4MATIC/all-wheel drive) 

Shown on Model 222, engine 176 with code 487 (Active Body Control (ABC)) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
Notice	Notes on avoiding damage through contamination and foreign objects		AH00.00-P-5000-01A
Notice	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Remove/install
1	Remove engine with front axle carrier.		AR01.10-P-2500MNL
2	Remove front engine mounts.		AR22.10-P-4330MNP
3	Remove screw (3) of the ABC hydraulic pump carrier from the engine carrier (1).	Screw, holder to hydraulic pump/engine carrier	*BA32.00-P-1007-01C
4	Remove ABC hydraulic pump.	Engine 176 in model 217, 222 with code 487 (Active Body Control (ABC)) except code M005 (Vehicles with 4MATIC/all-wheel drive)	AR32.50-P-0030LFM
5	Unclip brackets (21).
6	Place electric line (26) to one side.
7	Release and disconnect electrical connector from the refrigerant compressor (A9) and unclip electric line (25) from the oil line (41).
8	Remove screw (2) of the oil line (41) from the engine carrier (1).	Bolt, oil line to crankcase/engine support/oil pan (oil filter housing)	*BA18.30-P-1010-01N
9	Remove screw (40) of the oil line (41) from the crankcase.	Bolt, oil line to crankcase/engine support/oil pan (oil filter housing)	*BA18.30-P-1010-01N
10	Remove screws of the oil line (41) from the oil pan bottom section.		AR01.45-P-7555MNL
11	Remove oil line (41).	:  Replace sealing rings of oil line (41).
12	Remove screws (23).	Bolt, coolant feed pipe to crankcase/cylinder head/engine carrier/belt tensioner	*BA20.20-P-1002-01Q
13	Release clip (24).		AR20.20-P-7441-01RQ
14	Remove coolant line (20).
15	Remove screws (4).
Notice	Notes on threaded connections fastened using a tightening angle-based tightening process		AH00.00-P-0020-01A
		Bolt, engine support to crankcase	*BA22.10-P-1001-02C
16	Remove engine carrier (1) from the crankcase
17	Check engine carrier (1) for damage.	If the engine carrier (1) is damaged, ↓ Replace engine carrier (1).
18	Clean contact surfaces of the engine carrier (1) on the crankcase.
19	Install in the reverse order.