Remove/Install Trunk Lid - AR88.50-P-5000LF
Model 222
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Remove hinge bracket trim piece (2) | ||
| 2 | Remove warning triangle (6) from warning triangle bracket | ||
| 3 | Remove hazard warning triangle bracket (6) | ||
| 4 | Unscrew bolts (4) and remove umbrella holder (5) | ||
| 5 | Remove expansion clips (arrows A) | ||
| 6 | Remove expansion clips (3), unclip trunk lid paneling (1) with assembly wedge and remove until electrical connectors (12) on ambient lamp and right trunk lid/liftgate warning lamp (13) and ambient lamp and left trunk lid/liftgate warning lam (14) are accessible | Fig 2 | |
| Fig 1 | |||
| 7 | Disconnect electrical connectors (12) on ambient lamp and right trunk lid/liftgate warning lamp (13) or left trunk lid/liftgate warning lam (14) and ambient lamp and remove trunk lid paneling (1) | ||
| 8 | Disconnect electrical connectors from electrical wiring harnesses (10 and 11) in trunk lid (7) | ||
| 9 | Remove electrical wiring harnesses (10 and 11) from trunk lid (7) and lay down to side | ||
| 10 | Remove screws/bolts (8) | ||
| 11 | Loosen bolts (9) | ||
| 12 | Remove trunk lid (7) | ||
| 13 | Install in the reverse order | ||
| 14 | Adjust trunk lid (7) | AR88.50-P-5200LF | |
| 15 | Calibrate reversing camera and 360° camera with STAR DIAGNOSIS | MODEL 222 with CODE 218 (Reversing camera) with CODE 501 (360 degree camera) |
|
| AD00.00-P-2000-04B |