Remove/Install Rear Axle Level Sensor - AR82.10-P-0005ME

Model 167 With Code 489 (AIRMATIC Dual Control/semi-active air suspension) 

Model 167 With Code 613 (headlights left-hand-traffic) 

Model 167 With Code 620 (Right-hand traffic headlamps) 

Model 167 With Code 631 (Static LED headlamps, left-hand traffic) 

Model 167 With Code 632 (Headlamps, LED, static, right-side traffic) 

Model 167 With Code 640 (SAE dynamic LED headlamps, right-hand traffic) 

Model 167 With Code 641 (Dynamic LED headlamps, left-hand traffic) 

Model 167 With Code 642 (Dynamic LED headlamps, right-hand traffic) 

Fig 1: Rear Axle Level Sensor Components Location - Model 167 With Code 489; 613; 620; 631; 632; 640; 641; 642 (Right Side Shown)

Courtesy of MERCEDES-BENZ USA

Shown on right side of vehicle 

	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
Notice	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
2	Remove right or left rear wheel and tire assembly.		AR40.10-P-1102ME
3	Remove trim from transverse control arm (5).
4	Release and disconnect electrical connector (2) from left rear level sensor (B22/7) or from right rear level sensor (B22/10).
5	Remove screw (3) from holder (4).	Make sure that the retaining lug of the holder (4) is correctly positioned in the transverse control arm (5). Screw, linkage holder to transverse control arm	*BA82.10-P-1001-02H
6	Remove screws (6) and remove left rear level sensor (B22/7) or right rear level sensor (B22/10).	Do not twist left rear level sensor (B22/7) or right rear level sensor (B22/10). Pay attention to installation position. Bolt, level sensor to rear axle carrier	*BA82.10-P-1003-02H
7	Install in the reverse order.
	Calibrate
8	Calibrate left rear level sensor (B22/7) or right rear level sensor (B22/10) using vehicle diagnosis system.	If the left rear level sensor (B22/7) or right rear level sensor (B22/10) has been replaced.
			AD00.00-P-2000-06ME
	Check
9	Check headlamp adjustment and correct if necessary.	If the left rear level sensor (B22/7) or right rear level sensor (B22/10) has been replaced.
			AP82.10-P-8260Q