Remove/Install Radar Sensor In Rear Bumper - AR54.21-P-0704ME
Model 167
With Code 233 (DISTRONIC PLUS)
Model 167
With Code 234 (Blind Spot Monitoring)
Shown on model 167 With Code 233 (DISTRONIC PLUS)
Fig 1: Radar Sensor In Rear Bumper Components Location - Model 167 With Code 233; 234 (With Code 233 Shown)
Shown on model 167 With Code 234 (Blind Spot Assist)
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Topical note | Notes on preventing damage to electronic components due to a magnetic tool | AH54.00-P-0002-01A | |
| Remove/install | |||
| 1 | Remove rear bumper. | AR88.20-P-2200ME | |
| 2 | Unclip rear radar sensor (B92/6, B92/7, B92/10, B92/11). | ||
| 3 | Release and disconnect electrical connector a radar sensor (B92/6, B92/7, B92/10, B92/11). | ||
| 4 | Remove rear radar sensor (B92/6, B92/7, B92/10, B92/11). | ||
| 5 | Install in the reverse order | ||
| Finishing activity | |||
| 6 | Carry out commissioning of rear radar sensor (B92/6, B92/7, B92/10, B92/11). | When replacing the rear radar sensor (B92/6, B92/7, B92/10, B92/11). | |
| AD00.00-P-2000-06ME |