Remove/Install Windshield Heater Control Unit - AR54.21-P-0122ME
Model 167
With Code 597 (Heated windshield)
With Code 93B (Integrated starter alternator Gen. 1.)
Model 167
With Code 597 (Heated windshield)
With Code 94B (Integrated starter alternator Gen. 2)
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove seal on cover (1) in working area. | ||
| 2 | Unclip retaining clips (2). | ||
| 3 | Remove cover (1). | ||
| 4 | Use suitable tool to unclip and remove air intake scoop (3) at arrows. | ||
| 5 | Unscrew nuts (4) and remove windshield heater control unit (N61) with attached electric lines. | Do not crush or kink or subject lines to tension This will result in damage to the lines which may impair their functional capability. |
|
| 6 | Release and disconnect electrical connectors from windshield heater control unit (N61). | ||
| 7 | Install in the reverse order |