Tension Rear Axle Spring - AR32.20-P-0202-06ME

Model 167

except code 489 (AIRMATIC Dual Control/semi-active air suspension)

except code 490 (Electrohydraulic suspension)

	Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension	Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves.	AS00.00-Z-0001-01A
	Notes on repair work on suspension components		AH00.00-P-0100-01A

Fig 1: Identifying Clamping Plates (164 589 01 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Tensioning Device (202 589 02 31 00)

Courtesy of MERCEDES-BENZ USA

Install clamping plates (02, 03) in rear axle springs (1).
Ensure that clamping plates (02, 03) are correctly seated. Otherwise they may slip off.

Insert the clamping plates (02, 03) in such a way that as many spring coils as possible can be pre-compressed.
Insert tensioning device (01) into clamping plates (02,
Tensioning device (01) must latch audibly into clamping plates (02, 03). Otherwise they may slip off.
Only tension rear axle spring (1) far enough to enable it to be removed.
Do not use an impact wrench. Otherwise, the tensioning device (01) or the rear axle spring (1) may be damaged.

Shown on left side of vehicle

Courtesy of MERCEDES-BENZ USA