Remove/Install Right Front Body Acceleration Sensor - AR32.22-P-0007ME

Model 167 

with code 490 (Electrohydraulic suspension) 

Fig 1: Right Front Body Acceleration Sensor Components Location - Model 167 With Code 490

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
2	Remove cover above suspension strut tower.
3	Unclip engine compartment prefuse box (F150/3) from holder (2) and place to one side with connected lines.	Do not crush or kink or subject lines to tension. This will result in damage to the lines which may impair their functional capability.
4	Remove nuts (1) and remove holder (2).
5	Release and disconnect electrical connector (4).
6	Remove nut (3).
7	Remove front right body acceleration sensor (B24/4).
8	Install in the reverse order