Remove/Install Outer Trim On Seat Frame - AR91.10-P-1201CLA
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2023 Mercedes-Benz C43 AMG, 2022 Mercedes-Benz C43 AMG, 2021 Mercedes-Benz C43 AMG, 2020 Mercedes-Benz C43 AMG, and 2019 Mercedes-Benz C43 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 205.3/4
with code U22 (Lumbar support adjustment)
except code 409 (Left and right front multicontour seat)
except code 555 (AMG Performance seats)
except code P65 (Seat comfort package)
Model 238
with code U22 (Lumbar support adjustment)
except code 432 (Dynamic seats left and right)
except code P65 (Seat comfort package)
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Remove front seat. | Model 205.3 with code U22 (Lumbar support adjustment) except code 409 (Left and right front multicontour seat) except code 555 (AMG Performance seats) except code P65 (Seat comfort package) Model 238 with code U22 (Lumbar support adjustment) except code 432 (Dynamic seats left and right) except code P65 (Seat comfort package) |
AR91.10-P-1000LW |
| Model 205.4 with code U22 (Lumbar support adjustment) except code 409 (Left and right front multicontour seat) except code 555 (AMG Performance seats) except code P65 (Seat comfort package) |
AR91.10-P-1000LWR | ||
| 2 | Unclip trim (5) at top and remove downwards. | If installed. | |
| Fig 1 | |||
| 3 | Push trim (1) downwards and unhook from catch hooks (arrows). | ||
| 4 | Detach trim (1) and place to one side with electrical line connected. | ||
| 5 | Disconnect electrical connector from lumbar support adjustment switch (S109/2, S109/3). | ||
| 6 | Unclip lumbar support adjustment switch (S109/2, S109/3). | When replacing trim (1). | AR91.25-P-1436LWE |
| 7 | Remove cover (3). | ||
| 8 | Unhook electrical wiring harness from reinforcement (2) and place to one side. | ||
| 9 | Drill out rivets (4). | ||
| 10 | Release and remove reinforcement (2). | ||
| 11 | Install in the reverse order |