Remove/Install Rear Center Section Cover - AR68.30-P-4786ME
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2025 Mercedes-Benz Maybach GLS600, 2025 Mercedes-Benz GLS63 AMG, 2024 Mercedes-Benz Maybach GLS600, 2024 Mercedes-Benz GLS63 AMG, and 2023 Mercedes-Benz Maybach GLS600. However, it is still accessible from the selected car via links, so may be relevant.
Model 167
Shown on model 167.1
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Open tailgate. | ||
| 2 | Remove spare wheel from load compartment. | Model 167.9 with code 669 (Spare tire on steel rim) with code 811 (Advanced sound system) except code M036 (Maybach version) Model 167.9 with code 669 (Spare tire on steel rim) with code U68 (Active engine sound generator) except code M036 (Maybach version) |
|
| 3 | Release edge guard in the area of the rear-end center section cover (1). | ||
| 4 | Lift load compartment floor. | ||
| 5.1 | Remove screw (2). | Model 167.1 | |
| 5.2 | Unscrew left and right screws (2). | Model 167.3/9 Model 167.9 with code M036 (Maybach version) Screws (2) are behind a cover. |
|
| 6 | Unclip rear-end center section cover (1) from the attachment points (arrows A) and remove. | Fig 1 | |
| 7 | Install in the reverse order. |