Remove/Install Drive Cable For Panoramic Sunroof Roller Sun Blind - AR77.21-P-0230ME

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2025 Mercedes-Benz Maybach GLS600, 2025 Mercedes-Benz GLS63 AMG, 2024 Mercedes-Benz Maybach GLS600, 2024 Mercedes-Benz GLS63 AMG, and 2023 Mercedes-Benz Maybach GLS600. However, it is still accessible from the selected car via links, so may be relevant.

Model 167.1/9

With Code 413 (Automatic panoramic sliding sunroof)

Courtesy of MERCEDES-BENZ USA

	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove
1	Remove roller sunblind from panoramic sliding sunroof.		AR77.21-P-0215ME
2	Move drive cables (3, 4) manually toward the rear as far as possible (approx. 100 mm); then, remove the panoramic sliding sunroof roller sunblind drive unit (M12/5).		AR77.21-P-0493ME
3	Carefully pull out drive cables (3, 4) toward the rear and remove.
	Install
4	Push drive cables (3, 4) from the rear into the guides and insert by hand into the mechanical components at the front.	Helper required. The drive cables (3, 4) should disconnect flush with the guide tubes (1 a, 1 b or 2a, 2b) at the rear. Guide drive cables (3, 4) further into the gaps between the guide tubes (1 a, 1 b or 2a, 2b) by hand.
5	Install roller sunblind on panoramic sliding sunroof.		AR77.21-P-0215ME