Blockage Detection, Basic Function - GF82.00-P-1001A
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model all (CAR)
Overview
This document contains the following information:
- General
- Blockage detection
General
Blockage detection protects the component parts involved against damage caused by a load that is too strong and enables the setting of end points during normalization.
Blockage detection
A blockage is detected if during the actuation of an electric motor:
- The RPM signal of the electric motor is absent
- A force defined in the system is exceeded
The power consumption of the electric motor serves as a reference for the force.
Once a blockage is detected, actuation of the electric motor is immediately stopped.
Depending on the system, the actuation of the electric motor is reversed for a certain time or a certain way.