Remove/Install Accelerator Pedal - AR30.12-P-1321LF
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205
Model 217
Model 222
Model 253
Model 293
Shown on model 222
Shown on model 205 (with code ME05 (HYBRID DRIVE 80KW-VARIANT (INCLUDING PLUG-IN)))
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Switch off ignition. | ||
| 2 | Unscrew nuts (1), remove accelerator pedal (2) and place to one side. | Ensure that the wiring harness is not pinched. Otherwise malfunctions of the accelerator pedal (2) can occur. |
|
| *BA30.20-P-1001-03B | |||
| 3 | Disconnect electrical connector (3). | ||
| 4 | Disconnect electrical connection (4). | Model 205, 222, 253 with code ME05 (HYBRID DRIVE 80KW VARIANT (INCLUDING PLUGIN)) Model 293 |
|
| 5 | Remove accelerator pedal (2). | The accelerator pedal (2) must not be disassembled. It can be damaged and must be replaced otherwise. |
|
| 6 | Install in the reverse order |
ACCELERATOR PEDAL
| Number | Designation | Model 205 | Model 217 | |
|---|---|---|---|---|
| BA30.20-P-1001-03B | Nut, accelerator pedal to firewall | Nm | 8 | 8 |
ACCELERATOR PEDAL
| Number | Designation | Model 222 | Model 253 | |
|---|---|---|---|---|
| BA30.20-P-1001-03B | Nut, accelerator pedal to firewall | Nm | 8 | 8 |
ACCELERATOR PEDAL
| Number | Designation | Model 293 | |
|---|---|---|---|
| BA30.20-P-1001-03B | Nut, accelerator pedal to firewall | Nm | 8 |