Prepare Body Flange For Installation Of Window - AR67.10-P-1501-01P

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2023 Mercedes-Benz C43 AMG, 2022 Mercedes-Benz C43 AMG, 2021 Mercedes-Benz C43 AMG, 2020 Mercedes-Benz C43 AMG, and 2019 Mercedes-Benz C43 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 117, 129, 140, 156, 168, 169, 170, 171, 172.4, 176, 202, 203, 204.2/3/9, 205, 207, 208, 209, 210, 211.0/2/6, 212, 213, 215, 217, 218, 230.4, 231, 238, 240, 242, 245.2, 246, 253, 292, 414.700

Model 220 except code Z04 (Light armoring) except code Z07 (B7 armoring on special protection version)

Model 222 except code Z07 (B7 armoring on special protection version)

Model 463 as of model year 2019

The bonding area must be free of dust and grease.

Otherwise, the adhesive force of the adhesive material will be impaired.

If the degree of damage is ≤ 10 %, repair with primer stick. If the degree of damage is > 10 %, coat body flange with primer filler.

Otherwise corrosion damage may occur.

Use only primer fillers and primer sticks approved by Daimler AG:

Model 117, 129, 140, 156, 168, 169, 170, 171, 172.4, 176, 202, 203, 204.2/3/9, 205, 207, 208, 209, 210, 211.0/2/6, 212, 215, 217, 218, 230.4, 231, 240, 242, 245.2, 246, 253, 292, 414.700

Model 220 except code Z04 (Light armoring) except code Z07 (B7 armoring on special protection version)

Model 222 except code Z07 (B7 armoring on special protection version)

Use the constituents of the corresponding repair kit.

Model 213, 238

Model 463 as of model year 2019

Use the specified repair kit in the appropriate parts catalog.

Shown on model 171

Courtesy of MERCEDES-BENZ USA

Level residual adhesive material on body flange (1) down to a height of approx. 2 mm using suitable scraper and remove loose adhesive material.
Clean working area.
Clean bonding area (2) on body flange (1) with cleaner and rub dry with dry cloth.
Repair paint damage in bonding area (2) and on body flange (1) with primer stick or primer filler.
Observe the manufacturer's specifications for the curing and processing time of the primer filler.
Apply primer to areas of body flange (1) where no remaining or damaged adhesive is present.
The primer must flash off for at least 10 min.

Otherwise, the adhesive force of the adhesive material will be impaired.