LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2020 >> GLE580 >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Sliding Roof, Soft Top, Top Attachments - 205 Chassis) >> Testing & Repair >> Remove/Install Electric Motor For Soft Top Lock - AR77.39-P-5000LCA

Remove/Install Electric Motor For Soft Top Lock - AR77.39-P-5000LCA

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2023 Mercedes-Benz C43 AMG, 2022 Mercedes-Benz C43 AMG, 2021 Mercedes-Benz C43 AMG, 2020 Mercedes-Benz C43 AMG, and 2019 Mercedes-Benz C43 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 205.4 

Model 217.4 

Model 238.4 

G13023873Courtesy of MERCEDES-BENZ USA
WARNING Risk of injury.  Moving parts can pinch, crush or, in extreme cases even sever extremities. No parts of the body or limbs should be within the operating area of mechanical components when moving components. AS00.00-Z-0009-01A
WARNING Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
WARNING Risk of injury  when performing check and repair work in area of roll bar Keep body parts out of the area where the roll bars extend.
Do not use the cover in the area of the roll bar as a storage place for objects.
AS91.00-Z-0003-01LCA
REMOVINGINSTALLING Remove/install     
1 Remove trim from soft top (1) at front Model 217.4 AR68.30-P-4320LCA
    Model 205.4, 238.4 AR68.30-P-4320LWR
2 Disconnect electrical connectors (2) and expose wiring harness    
3 Remove lock linkage (3) at left and right locking hooks (4)    
4 Mark installation position of bolts (5) on bracket (6) and unscrew bolts (5) IMPORTANTInstallation:  Align brackets (6) according to markings.  
5 Remove lock linkage (3) with electric motor (7)    
6 Unscrew bolt (8)    
7 Mark installation position of lock linkage (3) on bracket (6)    
8 Remove lock linkage (3) from electric motor (7) and electric motor (7) from bracket (6) IMPORTANTInstallation:  Align lock linkage (3) with markings.  
9 Install in the reverse order