Remove/Install Subwoofer - AR82.62-P-7841ME
Model 167.1
With Code 811 (High-End sound system)
Shown on model 167 With Code 847 (3rd seat row)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Remove trunk floor (1). | ||
| 3 | Unclip trim (2) (arrows) and remove until to electrical connector of the vehicle interior KEYLESS-GO antenna (A2/61) is accessible. | Do not crush or kink or subject lines to tension. This will result in damage to the lines which may impair their functional capability. |
|
| 4 | Release and disconnect electrical connector of the vehicle interior KEYLESS-GO antenna (A2/61). | ||
| 5 | Remove rear-end center-section trim. | AR68.30-P-4786ME | |
| 6 | Remove stowage tray (3). | Model 167.1 with code 811 (High-End sound system) except code 847 (3rd seat row) |
|
| 7 | Unclip retaining clips (4). | Fig 1 | |
| 8 | Remove covers (5). | ||
| 9 | Unscrew nuts (8). | Model 167.1 with code 811 (High-End sound system) with code 847 (3rd seat row) |
|
| 10 | Remove screws/bolts (9). | Model 167.1 with code 811 (High-End sound system) with code 847 (3rd seat row) |
|
| 11 | Remove load compartment floor (6). | ||
| 12 | Release and disconnect electrical connector from rear subwoofer (High-end) (H22/35). | ||
| 13 | Unscrew nuts (7). | ||
| 14 | Remove rear subwoofer (High-end) (H22/35). | ||
| 15 | Install in the reverse order |