Retrofit Wiring Harness For Mercedes-Benz Dashcam At Rear With Existing Mercedes-Benz Dashcam At Front - AZ54.71-P-0003-01MEC
Model 167.3
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Topical note | Notes on retrofitting electrical/optical lines | AH82.00-P-0000-01A |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1133-06A | Silicon Spray Silicone-Fluid, 0.4 l art. no. 0893 221 000 | Adolf WUrth GmbH & Co. KG Reinhold-WUrth-Str. 12-17 74653 KUnzelsau-Gaisbach Germany Tel. +49 7940 15-0 Fax +49 7940 15-1000 http://www.wuerth.de |
| BR00.45-Z-1144-02A | Adhesive tape roll, non-woven Tesa tape, 50 meters, 50 mm wide | A 008 989 50 85 09 |
Connection scheme
Routing diagram
- Expose branch-off line for rear dashcam (arrow K).
- Expose black plug (8.1) of dashcam wiring harness (8).
To do this, remove the fabric tape (41) and pocket (40) from dashcam wiring harness (8).
- Route branch-off line for dashcam at rear of dashcam wiring harness (8) from driver's side fuse and relay module to A-pillar.
Route branch-off line for dashcam at rear above the window airbag (30).
- Route branch-off line for rear dashcam of dashcam wiring harness (8) on roof lining towards rear up to center of roof lining.
- Strap down excess lengths of dashcam wiring harness (8) in area of A-pillar.
- Fasten dashcam wiring harness (8) on roof lining using felt adhesive tape.
Shown with removed roof lining
- Remove rear roof frame cover (31).
- Open bracket (32) on left side of vehicle and remove cable duct (33).
- Remove cable duct (33) from liftgate and from rear roof frame.
- Route dashcam wiring harness (8) through opening in rear roof frame up to opening for cable duct at rear roof frame.
Shown with removed roof lining
- Route dashcam wiring harness (8) through cable duct (33) into liftgate.
- Route dashcam wiring harness (8) by dimension (a) beyond center of liftgate (line b) to the right.
a = 210 mm
Use a pull-through device. Silicone spray must be applied to the cable duct (33) on the inside before routing.
- Fix dashcam wiring harness (8) in place using cable ties (arrows G).
- Attach cable duct (33).