Install Windshield CROSSMEMBER - Ar62.25-P-1120-04LW

Model 205 

Model 253 

Model 293 

The next steps are shown on model 205.0.

The crossmember can be separated at the standard joints or cut, if required.

Installation of the crossmember when separated on the left at the standard joining point and on the right by cutting is shown below as an example.

Courtesy of MERCEDES-BENZ USA

1. Install crossmember (1), fit, and fix in place.
2. Drill rivet holes with a diameter of 6.7 mm in the crossmember (1) (areas A₁ , A₂ , B, C₁ and C₂ ).

   Drill rivet holes through the holes present in the crossmember (1) (area A₁ and C₁ ).

   Drill rivet holes through present holes in body (areas B and C₂ ).

3. Countersink rivet holes on the crossmember (1) (area C₁ and C₂ ).
4. Remove crossmember (1).
5. Deburr rivet holes on crossmember (1) and body on both sides.
6. Remove drilling chips.
7. Coat insides of the riveted joints with zinc dust paint (area A₁ , A₂ , C₁ and C₂ ).

   Courtesy of MERCEDES-BENZ USA

8. Apply 2-component adhesive to body in crosshatched areas.

   Apply 2-component adhesive to inside (area D).

   Observe pretreatment of bonding surfaces and manufacturer's specifications for drying and processing time of 2-component adhesive.

   Courtesy of MERCEDES-BENZ USA

9. Install crossmember (1) and fix in place.
10. Rivet crossmember (1) with rivet with a diameter of 6.4 x 12 (area E).
11. Rivet crossmember (1) with rivet with a diameter of 6.5 x 12.5 (area F).
12. Rivet crossmember (1) with Ø 6.4x14 countersunk-head rivet (area G₁ ).
13. Rivet crossmember (1) with 0 6.4x15.5 countersunk-head rivet (area G₂ ).
14. Crossmember (1) (area G₃ ).

    Courtesy of MERCEDES-BENZ USA

15. Crossmember (1) (area H).
16. Crossmember (1) (area I).

    Inert gas weld in intervals and allow welding area to cool down in between. Reduces heat distortion.