Remove/Install Wind Deflector - AR77.20-P-2500LW
WARNING: This page is about a different car, the 2023 Mercedes-Benz C300, 2022 Mercedes-Benz C300, 2021 Mercedes-Benz C300, 2020 Mercedes-Benz C300, and 2019 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205.0/1
with code 414 (Sliding Sunroof)
Model 213.0/1/2
with code 414 (Sliding Sunroof)
Model 253
with code 414 (Sliding Sunroof)
Model 293
with code 414 (Sliding Sunroof)
Shown on left side of vehicle
Fig 1: Wind Deflector Components Location - Model 205.0 With Code 414 (Shown On Left Side Of Vehicle)
| Risk Of Injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/Install | |||
| 1 | Open sliding roof. | ||
| 2 | Press wind deflector (1) at the left and right roof edge with long wedge toward the rear and unhook retaining tab (2) on the left and right upward. | Carefully press wind deflector (1) toward rear. Otherwise the retaining tabs (2) on left and right can be damaged. Helper required. Long wedge |
Fig 2 |
| 3 | Unhook spring (3) at the left and right out of the Sliding Sunroof frame and remove wind deflector (1). | Pull spring (3) on left and right toward front until sliding roof frame arrests. |
|
| 4 | Install in the reverse order | ||
| 5 | Connect vehicle diagnosis system, read out fault memory and perform teach-in run for automatic reversing function of Sliding Sunroof. | ||
| Model 293 with code 414 (Sliding Sunroof) | AD00.00-P-2000-06FR | ||
| Model 205.0/1 with code 414 (Sliding Sunroof) Model 213.0/1/2 with code 414 (Sliding Sunroof) Model 253 with code 414 (Sliding Sunroof) |
AD00.00-P-2000-04B |