Remove/Install Wind Deflector Net - AR77.25-P-1004LWR
WARNING: This page is about a different car, the 2023 Mercedes-Benz C300, 2022 Mercedes-Benz C300, 2021 Mercedes-Benz C300, 2020 Mercedes-Benz C300, and 2019 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205.4
With Code 288 (Draft Stop For Convertible)
Model 217.4
Model 238.4
With Code 288 (Draft Stop For Convertible)
Shown on left side of vehicle
Fig 1: Wind Deflector Net Components Location - Model 205.4 With Code 288 (Shown On Left Side Of Vehicle)
| Remove/Install | |||
| 1 | Switch on ignition | The ignition must remain switched on during the entire repair procedure. |
|
| 2 | Move out wind deflector (1) with soft top closed | The wind deflector (1) is moved to the service position. |
|
| 3 | Unhook tab (3) on both sides | ||
| 4 | Remove adhesive strip from cover (4) | If installed. |
|
| 5 | Unclip cover (4) on left side | ||
| 6 | Unclip lower net weatherstrip (5) on left side (arrow A) | ||
| 7 | Uniformly pull net (2) out together of lower net weatherstrip (5) and upper net weatherstrip (6) to left (arrows B) | The left and right tab (3) must point toward rear. |
|
| Clean | |||
| 8 | Clean guides for lower net weatherstrip (5) and upper net weather strip (6) | ||
| 9 | Install in the reverse order |