Remove/Install Glass Roof On Tilting/Sliding Roof - AR77.20-P-2852LW
WARNING: This page is about a different car, the 2023 Mercedes-Benz C300, 2022 Mercedes-Benz C300, 2021 Mercedes-Benz C300, 2020 Mercedes-Benz C300, and 2019 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
Model 205.0/1
with code 414 (Sliding Sunroof)
Model 213.0/1/2
with code 414 (Sliding Sunroof)
Model 253
with code 414 (Sliding Sunroof)
Model 293
with code 414 (Sliding Sunroof)
Fig 1: Glass Roof On Tilting/Sliding Roof Components Location - Model 205.0 With Code 414 (Shown On Right Side Of Vehicle)
Shown on right side of vehicle
| Risk Of Injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/Install | |||
| 1 | Move sliding roof panel (1) to tilt position. | ||
| 2 | Open sliding roof trim (3). | ||
| 3 | Remove boot (2) on left and right. | Extend boot (2) on left and right first, then at bottom and then at top. Otherwise the boot (2) on left and right can be damaged by bending. Only install boot (2) on left and right after adjustment. |
|
| 4 | Remove screws (4) on the left and right. | Do not tighten the screws (4) until after adjustment. |
|
| 5 | Remove sliding roof panel (1). | Helper required. |
|
| 6 | Install in the reverse order. | ||
| 7 | Adjust sliding roof panel (1). | Model 205.0/1 with code 414 (Sliding Sunroof) Model 213.0/1/2 with code 414 (Sliding Sunroof) |
AR77.20-P-1100LW |
| Model 253 with code 414 (Sliding Sunroof) | AR77.20-P-1100CW | ||
| Model 293 with code 414 (Sliding Sunroof) | AR77.20-P-1100EQ |