Apply Adhesive Material For Front Fixed Element Of Panoramic Sliding Sunroof - AR77.21-P-0803-04NKA

Model 117, 156, 176, 205, 222, 253 

with code 413 (Panoramic Sliding Sunroof/Glass Roof) 

Model 222 

with code 398 (Panoramic Roof With MAGIC SKY CONTROL) 

Courtesy of MERCEDES-BENZ USA

Shown on Model 176 with code 413 (Panoramic Sliding Sunroof/Glass Roof) 

Courtesy of MERCEDES-BENZ USA

Shown on Model 205 with code 413 (Panoramic Sliding Sunroof/Glass Roof) 

Courtesy of MERCEDES-BENZ USA

Shown on Model 222 with code 413 (Panoramic Sliding Sunroof/Glass Roof) 

Shown on Model 156 with code 413 (Panoramic Sliding Sunroof/Glass Roof) and with code 700 (Vehicle production location China) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Shown on Model 156 with code 413 (Panoramic Sliding Sunroof/Glass Roof) except code 700 (Vehicle production location China) 

1. Guide electric squeeze gun with application nozzle along bonding surfaces (1) on panoramic Sliding Sunroof frame (2) and apply adhesive material evenly.

   Following the application of the adhesive material, the outer adhesive bead must result in a closed profile.

   Otherwise leaks may occur.

   Only use the repair kit approved by the manufacturer from the replacement part system. 

   Otherwise, adhesion problems will occur. 

2. Immediately remove soiling caused by adhesive.

   Only if necessary.

3. Completely press excess adhesive out immediately after application and dispose of it properly.