LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2020 >> GLE450 >> Repair and Diagnosis >> External Pages >> Different car >> Section 288 (Interior Equipment - 205 Chassis) >> Testing & Repair >> Remove/Install Side Paneling In Trunk >> Remove/Install Side Paneling In Trunk - AR68.30-P-4800LWR

Remove/Install Side Paneling In Trunk - AR68.30-P-4800LWR

WARNING: This page is about a different car, the 2023 Mercedes-Benz C300, 2022 Mercedes-Benz C300, 2021 Mercedes-Benz C300, 2020 Mercedes-Benz C300, and 2019 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205.4, 238.4 

MODIFICATION NOTES

22.03.2018 Special tool changed. Operation step 7  
Fig 1: Side Paneling In Trunk Components Location - Model 205.4
G14187629Courtesy of MERCEDES-BENZ USA

Shown on right trim (8) on model 205.4 

G14187630Courtesy of MERCEDES-BENZ USA

Shown on left trim (8) on model 238.4 with code 550 (Trailer hitch) 

WARNING Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
  Notes on HANDS-FREE ACCESS   AH80.61-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Remove cover (2).   AR68.30-P-4660LWR 
2 Remove rear-end center-section trim.   AR68.30-P-4785LW 
3 Unscrew nuts (11).    
4 Remove tie-down eye (6). TORQUE SPECIFICATION Screw/bolt for tie-down eye *BA68.50-P-1001-03I 
5 Separate partition (7) from trim (8) and place behind guide (9). IMPORTANT Pay attention to installation position.  
6 Remove hook (12). Model 238.4  
7 Remove retaining clips (4). SPECIAL TOOL Dismantling tool Fig 2
8 Unhook trim (8) from guide (9) and release. INSTALLATION IMPORTANT Ensure that paneling (5), seal (10) as well as retaining bracket of net (3) are installed correctly.  
9 Disconnect electrical connector from left trunk rear seat backrest release button (S54/9) or right trunk rear seat backrest release button (S54/10).    
10 Disconnect electrical connector for right trunk lamp (E18/4). When removing right paneling (8).  
11 Disconnect electrical connector for left trunk lamp (E18/5). Model 238.4
When removing left paneling (8).
 
12 Disconnect electrical connector for trailer hitch release switch (S62/24). Model 205.4, 238.4 with code 550 (Trailer coupling)
When removing left paneling (8).
 
13 Remove trim (8).    
14 Install in the reverse order.    
INSPECT Check     
15 Perform function test for corresponding component parts.    
CARGO RETAINERS

Number Designation Model 205 Model 238
BA68.50-P-1001-03I Screw/bolt for tie-down eye Nm 24 24
Fig 2: Identifying Dismantling Tool (000 589 95 63 00)
G12619044Courtesy of MERCEDES-BENZ USA