LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2020 >> GLE450 >> Repair and Diagnosis >> External Pages >> Different car >> Section 288 (Interior Equipment - 205 Chassis) >> Testing & Repair >> Remove/Install Interior Paneling On Roll Bar - AR68.30-P-1380LWR

Remove/Install Interior Paneling On Roll Bar - AR68.30-P-1380LWR

WARNING: This page is about a different car, the 2023 Mercedes-Benz C300, 2022 Mercedes-Benz C300, 2021 Mercedes-Benz C300, 2020 Mercedes-Benz C300, and 2019 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205.4 

Model 238.4 

Fig 1: Interior Paneling On Roll Bar Components Location - Model 205
G14187531Courtesy of MERCEDES-BENZ USA

Shown on model 205.4 

G14187532Courtesy of MERCEDES-BENZ USA

Shown on model 205.4 with code 235 (Active Parking Assist with PARKTRONIC) 

WARNING Risk of injury.  Moving parts can pinch, crush or, in extreme cases even sever extremities. No parts of the body or limbs should be within the operating area of mechanical components when moving components. AS00.00-Z-0009-01A
WARNING Risk of injury  when performing check and repair work in area of roll bar Keep body parts out of the area where the roll bars extend.
Do not use the cover in the area of the roll bar as a storage place for objects.
AS91.00-Z-0003-01LCA
REMOVINGINSTALLING Remove/install     
1 Cover both rear fenders    
2 Unlock backrest in rear    
3 Move soft top to repair position R2 INSTALLATION IMPORTANT Completely close soft top. AR77.30-P-1030LWR
4 Completely open right and left side window in rear    
5 Remove expansion rivet (1) on right and left side of vehicle    
6 Unscrew bolts (2) on right and left side of vehicle    
7 Remove covers (3) o right and left side of vehicle    
8 Move soft top to repair position R4 INSTALLATION IMPORTANT Move soft top to repair position R2. AR77.30-P-1030LWR
9 Remove both head restraints in rear   AR91.16-P-1770LWR
10 Remove screw/bolts (5, 6, 7)    
11 Unclip paneling (4) upward and turn    
12 Disconnect electrical connector (8) from rear parking system display (A44/3) and remove paneling (4) Model 205.4 with code 235 (Active Parking Assist with PARKTRONIC)  
13 Remove rear parking system display (A44/3) from paneling (4) Model 205.4 with code 235 (Active Parking Assist with PARKTRONIC) When replacing paneling (4).  
14 Install in the reverse order